-
“John represented me at my hearing in Fairfax County Circuit Court for my Petition for Restoration of Firearms Rights. My case was a bit complex and it incorporated some new legislation that John was very educated on. The legislation was so new that the Commonwealth’s Attorney and the Judge did not have any knowledge of it. John’s actions in the courtroom to bring the new legislation to the attention of the court were astonishing and brilliant; even bringing a smile to the Judge and pat on the back from a fellow attorney after the hearing.
John’s flat rate pricing for representation is amazingly affordable. He is true to his word, communicates through out the entire process and works diligently to represent you. I highly recommend John Pierce.” - Shawn
Outstanding Service
“I contacted John via email regarding trust and estate work that I needed and questions that I had. He called me that same day, walked me through the process, took adequate time and was very patient in responding to my questions. He is very down to earth and professional. I was astounded as I found he was on travel, yet he took the time to personally contact me. He was very responsive in following up with the documents that I needed. I am extremely pleased and appreciative of the time he took with me and his outstanding level of service. I've worked with a number of attorneys in my profession and John exceeds the standards that I am accustomed to. I highly recommend him.” - Ron
Category Archives: Manufacturing
May a machine shop allow customers to use their machinery to finish 80% lowers?
I was recently contacted by a firearms enthusiast who is also the owner of a machine shop. He wanted to know if he could host an event where he opened his shop to a group of fellow shooters so … Continue reading
Posted in 80% Lower, ATF, ATF Ruling, BATFE, Manufacturing, Regulatory Rulemaking
Comments Off on May a machine shop allow customers to use their machinery to finish 80% lowers?
Why do some approved Form 1’s say “FORM 1 REGISTRATION” in box 4a?
I recently received a call from a client who had received his approved Form 1 for a self-manufactured suppressor. The Form 1 application had been submitted pre-41F via eForms. In reviewing the approved form in preparation for having his tube … Continue reading
Posted in 41F, 80% Lower, Administrative Law, ATF, BATFE, eForms, Engraving, Federal Law, Form 1, Manufacturing, SBR, Suppressors
Comments Off on Why do some approved Form 1’s say “FORM 1 REGISTRATION” in box 4a?
Do you have to register for ITAR if you are only manufacturing AR-15 uppers?
In my last post I answered the question of whether or not an FFL is required if one is only manufacturing and selling AR-15 uppers. Almost immediately I was asked a follow-up question about whether or not a person who … Continue reading
Posted in AR-15, ATF, BATFE, Federal Law, ITAR, Manufacturing, Uppers
Comments Off on Do you have to register for ITAR if you are only manufacturing AR-15 uppers?
Do you need an FFL to manufacture and sell AR-15 uppers?
I was recently asked whether an FFL is required to manufacture and sell AR-15 uppers. The answer is ‘no‘ but I want to caution readers that this would not necessarily be the case if the upper in question was for a … Continue reading
Posted in AR-15, ATF, BATFE, Federal Law, FFL Issues, Manufacturing, Uppers
Comments Off on Do you need an FFL to manufacture and sell AR-15 uppers?
